INDUSTRIAL DEGREASER FG is an innovative solvent blend that is excellent for use where rapid turnaround is necessary and low flash point solvents can be used. Dissolves and removes:

• Greases
• Oils
• Lubricants
• Adhesives and contaminants from:
  • Equipment
  • Machinery
  • Motors and metal parts

• NSF A8 and K1 registered (N 140255 and 140250) for use in food industry
• Cuts through dirt and grease
• Fast evaporation to minimise downtime leaves no residues
• Easy 'in place' cleaning with minimal odour
• Non-corrosive and non-staining
• Safe on most plastics coatings and rubbers (always test prior to use)
• Aerosol fitted with a 360° Spray System for all angle use - even upside down

APPLICATIONS

• Electric motors & Mechanical brakes and clutches
• Air tools & Pumps
• Material handling equipment & Dies
• Generators & Air conditioners and compressors
• Wire ropes & Bearings
• General degreasing and oil removal & Fork lift trucks
• Sprockets & Moulds
• Chains

DIRECTIONS

• Can be used by:
  • Spraying
  • Immersion
  • Dipping or Wiping

• Apply liberally and allow excess to run off
• Air dry or dry with absorbent cloth. Repeat if necessary
• Test a small area prior to use to check materials compatibility. Do not use on sensitive electronic equipment
• Ensure adequate ventilation. Do not use on energised equipment
• Rinse with potable water. Allow to dry thoroughly and vapours disperse before reactivating system

SPECIFICATIONS

• NSF Registered - Category : Aerosol A8 + K1 (N 140255) : Bulk A8 + K1 (N 140250)
• Appearance : Colourless Liquid - Sweet Odour
• Specific Gravity (@ 20°C) : 0.808
• Flash Point (closed cup) : 25°C
• Boiling Range : 100-170°C
• Freezing Point : < -30°C
• Evaporation Rate (ether = 1) : 19
• Vapour Density (vs air = 1) : 4
• Kauri-Butanol Value : > 150
• Hildebrand Solubility Parameter (calc.) : 8.206
• Hydrogen Bonding Index (calc.) : 0.384
• Fractional Polarity (calc.) : 0.037
• Viscosity (@ 20°C calc.) : 0.76 mPa.s
• Surface Tension (@ 25°C est.) : 23 mN/m
• Plastics Compatibility : Safe On Most Plastics (Test Prior To Use)

STORAGE

The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.